USFamily.Net

Connecting families, communities and businesses for over 7 years

usa.gif (12791 bytes)

  HOME HELP CONTACT US

  WEBMAIL MY ACCOUNT USE POLICY

 
Internet Services


Dial-up
DSL
------------------------
E-mail
Web Hosting
------------------------
Support
My Account
------------------------
Computer Care
------------------------
Search The Web


 Search Help

 
DSL > DSL Setup
Configure Actiontec DSL Modem (Actiontec Firmware) for DSL-W Customers

This is the configuration guide for most Actiontec DSL modems using the Actiontec firmware. If you have USFamily.Net DSL service within Minnesota, and your username does not start with DSL-W, please go here to configure your modem. If you need help configuring your DSL modem to connect to the Internet, please contact us.

1) Access the Actiontec gateway's web interface by entering the IP address 192.168.0.1 in the address bar of a web browser. If you have a screen showing the Qwest logo, please go here to setup your modem.

2) Click on Setup / Config.



3) Click on Begin Basic Setup.



4) Click on Next.



5) Select PPPoA, make sure PPP auto connect is checked, and then enter in your username and password to the corresponding fields. Once you're done, click on Next.



6) Click on Save and Restart and you're finished.

Did this Frequently Asked Question provide the information you were looking for? Provide us with your Feedback and suggestions for improving this FAQ.


Email FAQ to: